Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,We have in essiance 2 sides of the network. One side EIGRP and the other OSPF. We also are doing OSPF in some of our EIGRP due to Nortel Lans. We redistribute OSPF and EIGRP between the Nortel 8600's and cisco wan routers.Now to the ques...
I have users using the Cisco dial out utility to access other devices around the world. I do not want the dialout users to be authenticated. But I want to manage my as5xxx with my Tacacs server. What I am seeing, I have not implemneted aaa, is whe...
You will need to get the debugs from both sides. But from the time you say the connection stays up. I would guess that DPDs are not being answered. Debugs would tell you this. Anything chage?
I am assuming that all 3 ISP connections terminate on the 2621. If this is the case, all you need to make sure of is that routing is set up properly. Default gateway of the pix is 2621. And the 2621 routes the vpn traffic to the interface on the P...
If I remember correctly PIX version 7.0 will let you do this. Or, you can configure a direct lan2lan to each pixes. Just remember you will have to change the set peer and the isakmp key every time the ip changes. Anther option is, get some routers...
I would be guessing but sounds like a nat or a routing issue. I would need to see a "show cry ip sa" from both pixes. A config from both pixes would be helpful too.
