Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Factory defaults terminal problemAs I mentioned in previous post I made a factory default reset,now I connect to my console,with putty:Serial type, speed 9600... OpenNow the black screen appears and I cant nothing write there... trying ctrl +c nothin...
Hello!I tried to reset the router, CISCO 2800 router factory default > I used this instructions>Method 1This method uses the config-register 0x2102 command in global configuration mode.Check the configuration register on the router by issuing the ...
Hello fellows!Just began to start with CISCO Router 2800, here is the sceme:So, we have 2 interfaces on router:FA 0/0 192.168.100.200 ( It is from the outside netowrk which provide me the internet, the Internet server is 192.168.100.100)FA 0/1 192.16...
Hello !I have a question, please answer as soon as possbile.Look I'm new in routing, just lerning CCNA Discovery course, there is the problem:okay, I'm setting up a ROUTER, and 2 Switches, I configure it through terminal:the final result we have:eth ...
So, i think it is normal that it says so, cause it has a image kept of his standard IOS and when you reset your router it automaticaly reinstall the IOS,so I think you should try to buy another card with more memory or just try to delete the instalat...
ok while i'm doing that i have one more question... i cant solve it finaly..so, u are experts and i would like to hearyour advice please.... the situation:There is an external network: 192.168.100.100 (the server from inet comes)I create interface: ...
would u like to enter initial configuration dialog ? yes/ nowhat should i select?I just wanna boot the web interface and so on.. and after that to configureP.S and one more question... please say me how to set the default gateway on the router throu...
