Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm kinda confused. I want 3 remote locations to communicates with CUCM . So I decided to use IP Helper.I have 4 Routers. HQ router R0, and Remote Routers; R1,R2,R3. CUCM is connected to the Core Switch in HQ. DHCP Server is configured in Core Switch...
Any assistance here would be greatly appreciated! I have an issue with my ASA 5545-x, it refused to boot from flash. I have backup, formatted the Flash, use Rommon to boot via TFTP and it boot fine and the old configuration work. I copied the image ...
I will try and get SmartNet contract on it. Put there is a lot of Contract available for the devices.
Please advice on the appropriate contract that will allow for BIOS update and software Image update. Thanks
Thank you very much.I have not reseating the eUSB, only the RAM, but I have placed a USB which is Fat16 formatted and I could see the files on it from the ASA. I placed the ASA Image in Disk1:I have tried this lineASA#(Config) system disk1:/asa992-sm...
Thank you very much.
I have not try to reseat the eUSB, only the RAM, but I have placed a USB which is Fat16 formatted and I could see the files on it from the ASA. I placed the ASA Image in Disk1:
I have tried this line
ASA#(Config) system disk1:/as...
Thank you very much.
I have not try to reseat the eUSB, only the RAM, but I have placed a USB which is Fat16 formatted and I could see the files on it from the ASA. I placed the ASA Image in Disk1:
I have tried this line
ASA#(Config) system disk1:/as...
