Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have two 1310G bridges, one configured as a Root the other as Non Root. The root is attached to a 3560 switch. I have configured VLAN 15 (Management) and VLAN 573 (Client) on the 3560. The Root and Non Root bridges have the same VLANS, and VLAN ...
I work for a SP. One of our clients wants to use his own VLANs between buildings. I understand how Q-in-Q truncking works. However, I read somewhere, and I cannot retrieve the document, that the tunnel port needs to be Fast Ethernet (Hard coded to 10...
I finally got around to implementing this setup.. The upgrade toc1310-k9w7-tar.124-10b.JDA2 addressed my inability to trunk two vlans to my 3560 switch. So I got that working. I think there must be a bug in the .JA version.I'm still having an issue ...
That would be very much appreciated and is excellent timing. I'm going, for the third time, to erase all configs and start from scratch.Looking forward to your reply.Thanks,Rob
Sorry for not getting back to anyone on this. Firstly, I was on vacation. Secondly I just recieved a new set of 1310s so I can start troubleshooting on them once I set them up in my office.The ones that are having this issue are in production and wou...
Jeff, thanks for your suggestion.I made the changes last night, keeping only the Managent SSID and the associated VLAN, which in my case is 15, and configured as Native.I still could not get the client VLAN to work with this switch port config:Switch...
