Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a Router behind the PIX in the inside where some difrent networks exists.. when I establishe the VPN using the vpn client, the PC it is only posible to view the segment from the Inside PIX but no the networks that are behind the router.. in...
Hi, already configure my pix for vpn and it’s working but only when I connect trough a ISP that assign IP public addressing (Im using VPN Client 3.0 for clients and terminating the VPN in a PIX ) if I use a ISP that assign private addressing the VPN ...
Hi, already configure my pix for vpn and it’s working but only when I connect trough a ISP that assign IP public addressing (Im using VPN Client 3.0 for clients and terminating the VPN in a PIX ) if I use a ISP that assign private addressing the VPN ...
Ok, I have a crash that I believe matches the vulnerability.
#############################################################
: Saved_Crash
Thread Name: IKE ReceiverPage fault: Address not mapped vector 0x0000000e edi 0x00001720 esi 0xa954f534 ebp 0xa9...
Certainly, exist differences between both implementation, but they run as the same principle of the ipfilter, you may wan to consider things like failover, stateful failover, easy user administration using CSPM and PDM, IP Nat Pools and certainly a b...
mm... Actualy you can do URL Filter with a Content Engine witch use Squid for this operation, practicaly it's not much diferense betewn the GNU Squid and the Cisco Squid they are based on the same source...
Yep, Im using CSPM 3.0 and I have some issues about it, for example:How do I create the port range? Because the policy editor only permit traffic for specific application like http, ftp, ssh etc.. or IP, UDP and TCP but no for ranges port TCP…already...
