Hi all, I am experiencing an issue with properly configuring an ASR1000 BGP router with 2 different upstream ASs for redundancy both sending default-route only.I have properly configured as-path prepending and local preference to influence in/out tra...
Hi all,I am experiencing an issue with STP trying to connect two gig ports of an ASR1006 to a couple 2960S switches for redundancy. The two 2960S are not stacked.On the ASR1006 side the interfaces are bridged and configured as follows:spanning-tree m...
Hello all, I am trying to setup Cisco ASA 5510 to allow ICMP protocol from inside to any outside hosts only. I have been able to deny ICMP from outside, however I am unable to allow from inside. Any hints would be much appreciated.
Thank you Giuseppe, now this question is clearer to me, i will try your suggested solution of switching ports to trunk and removing the port channel between the two 2960S.As a side question, stacking the two 2960S could solve the issue ? In this case...
Thank you for your answer, could you please elaborate more on this as I didn’t understand exactly what’s the point here, I know the asr is not a switch so how could I connect two physical bridged ports of the asr to 2 different 2960S preventing netwo...