Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there an administration guide for customizing the 7945G and 7965G in CUCME? I'm running CUCME 4.2 and all the documentation I can find is specific to CUCM. Also, is Cisco Phone Designer supported in CUCME, or are there plans to support it?Thanks
I know this works with routers, but can't seem to get it to work on the ASA 5510 (8.0(4)). Basically, the requirement is for multiple L2L IPSec Tunnels to terminate to multiple external IP addresses on the same ASA. I have the crypto maps configured ...
I have a 4240 IPS in inline interface mode between our edge firewall and core switch. This connection is a trunk port with 2 VLANs, lets call them A and B. Everything works 100% fine between VLANs (the firewall is doing the inter-vlan routing) with t...
I found a few threads about 3rd-party SIP phone support in CM...but what about CME? I haven't found any official announcements or documentation on CCO or here in the forums. I'm running CME 4.0 and it definitely doesn't appear to be supported...maybe...
My question is: Are there limitations/nuances for configuring IPSec tunnels on Catalyst 6500s in software (without the VPN module).I recently took over a management of a Catalyst 6500 and have run into a roadblock while trying to configure an IPSec t...
Assuming you can ping both firewalls, the problem is that the firewall pair shares the same config and therefore, the same SNMPv3 engineID. Some NMSs (e.g. WhatsUp Gold) do not support this and therefore only 1 firewall in the pair can be queried.Doe...
Let me rephrase...I need to know where I can access the "phone specific configuration" in CUCME.In CUCM you go to devices->phone->phone specific configuration in the GUI, but I see no such thing in the CUCME GUI...is this just a limitation of the CUC...
Well back to my original question then...where is this admin guide? All I see is the one for CUCM (http://www.cisco.com/en/US/docs/voice_ip_comm/cuipph/7965g_7945g/7_0/english/administration/guide/65adm70.pdf)
