Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Can anyone advice, whether VSS technology support on 3560 switches.I'm planning to intergrate new Cisco 2x6509 with VSS and all the access swtiches 3560's uplink to core 6509if not support, whar will be the solution or any bug fixing or new IOS re...
Hi,Is there any possibility of configuring the both LDAP and the RSA(SID) for authentication (Basically it should be first authorize from the LDAP and second from the RSA ID) ?
Some area to check and TS1. Local user setup and configuration2. VPN Split-tunnel Configuration3. Routing (Sync/Async, etc.)4. Local Firewall, AV configurations5. Group policy
Please find below some guidance document for Split-tunnelling configuration.https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/100936-asa8x-split-tunnel-anyconnect-config.html https://www.cisco.com/c/en/us...
When you using PBR, you have to select specific Source address to route to specific next-hop. Did you specify which source subnets you need to go via MPLS and ISP1 (as per ACL its Allowed all Source) ?
Did you want to apply conditional static route...
Please check your encryption domain access list is allowed the loopback IP you want to source ?
also try to run "sh cry ipsec sa" to see the allowed traffic via the IPSec tunnel.
