Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,We have an ISE 2.4. One of the Endpoint Identity Group was mistakenly reset by a helpdesk and now all users of that profile are being asked to re authenticate. After re authentication, the user is allowed network access but disconnected afte...
Hello all,I have an ASA that I will like to enable the VPN-3DES-AES license. Unfortunately, we have been using this device for the past few years and the supplier did not supply us with the SKU PAK (white sheet that comes with the box). Is there a wa...
Hello all,I have a funny problem and it is taking up my whole time.I am doing a hub and spoke network through and ipsec vti.after I have done the configurations, all works well but funny enough, I cannot access yahoo or cisco from the spoke. All ot...
Hello all,I have a funny problem and it is taking up my whole time.I am doing a hub and spoke network through and ipsec vti.after I have done the configurations, all works well but funny enough, I cannot access yahoo or cisco from the spoke. All othe...
Hi all,Thanks for all your help. The problem is resolved. It was the mtu issue on the host pc. Initially I set the mtu on a different LAN interface card. I changed the correct the mtu on the correct interface and BINGO!, things yahoo, cisco and all o...
I have set the host pc's mtu to 1300 but no luck. I can access all website when I take off the tunnel but immediately I put it back, yahoo.com cisco.com starts timing out.Any more help will be appreciated
