David Smith

OK, so this one looks good now, I see the mid-call INVITE for T38, GW responds with 200 OK, then the...

Looks good, for the most part.The call connects, then the fax server sends a mid-call INVITE for T38...

The fax server is sending a mid-call INVITE for T38 caps after the call has been answered and set up...

Yup, CUBE is supported on the 3725 platform, see below:http://www.cisco.com/en/US/customer/docs/ios/...

Hello Hasan,I'm wondering if this is a simple routing issue...where the phone can reach the CCME (17...

Hasan,The issue here is that CCME sends 200 OK to the INVITE for the answer, but CCME never receives...

Hey Steve,Yeah, through Telnet...like you did before, just log in, configure the buffer configs...th...

Hey Steve,OK, you're running the correct load...and I don't see any issues with your config, it all ...

You can check this on the phone itself:Click on "Settings", it's the button that looks like a piece ...

OK, thanks Steve.Do you know how to log into the router using telnet or SSH? If so, you can use some...

Sounds like it may be a phone load issue.Does this happen only on one particular 504G or all 504G ph...

As of now, yes, but it will be available for CCME/ISR/ISRG2 very soon, this is meant to be a replace...

Is the call coming in over FXO or PRI?If FXO please grab:conf tno logging conno logging rate limitlo...

Hey Rich,You shouldn't have to reboot the box, tftp service will always be running on the UC5XX.As l...