Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,connecting the OA to an external port of the cisco switch 3020 will create a loop, because the OA is already connected to the switch via signal backplane.so you can connect to the OA via the IP address ( plug a laptop to an external port of...
Hello,as shown in the link below :http://www.cisco.com/en/US/products/sw/iosswrel/ps1828/products_tech_note09186a00800a65d0.shtmlthe cpu is used by both :1.process2.interrupt levelin our case, 10% is the total cpu utilization4.33% for the process5.66...
Hello all, type the command : remote command switch show bootand if the config register value is 0x2100 , then type :config-register 0x2102write memretype the command remote command switch show boot , to see if the value was changed.and finally reloa...
