Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
6500 with SUP2/MSFC2/PFC2IOS 12.2(18)SXD2 I have an IP subnet of 172.16.0.0/16 on vlan 1 and just configured a vlan 145 interface and bound 172.16.145.0/24 to it. When I did that I get a message that vlan 145 IP overlaps with vlan 1. No problems yet,...
During the basic configuration of the WISM modules it asks for WLAN 1 SSID or netowrk name. Instructions says "This is the default SSID that lightweight access points use to associate to a controller"This WLAN is listed as disabled but using 802.1x a...
I have the same problem on adsl or vdsl and 850s or 870s. I am having a hard time catching the issue while it is happening to troubleshoot. I would also like some guidance on how to single out the true issue.
Do all four controller dynamic interfaces have different IP addresses on same subnets as lan VLANs?. If so would there not be an interuption in service if a controller went down, and an AP had to switch to another controller with different dynamic in...
