Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 ASA 5555s set up in an Active/Standby scenario. Primary IP address is 192.168.215.17 and standby is 192.168.215.18. Currently Secondary ASA is active. If it is fail-over to Primary ASA, I am unable to access asdm using 192.168.215.17, but ab...
Hi,
I connected cables to Gig0/0, Gig0/2 and Gig0/3 in ASA firewall, but the command "show interface ip brief" shows that Gig0/0, Gig0/1 and Gig0/2 ports are UP.
Eventhough there is no port configuration in Gig0/3 (port is shutdown mode as per confi...
Hi,
I am facing some issues in accessing ASA interface using SSH from remote LAN. site to site tunnel created in VPN device. Local subnet is 192.168.208/21 and remote subnet is 192.168.144.0/24.
From local LAN I am able to access inside interface of ...
Hi,
I setup a site-to-site VPN from siteA to siteB. When I try to connect using anyconnect vpn client, siteA LAN is reachable, but siteB LAN is unreachable.
NAT rules
nat (OUTSIDE,OUTSIDE) source static Anyconnect-object Anyconnect-object destinatio...
I created a UC service named "Directory" in CUCM. And added UC service in service profile named "Jabber".
Screenshots of UC service and service profile are attached.
Please check the configuration and let me know if there is any error.
I want to incorporate Directory on jabber android without AD using the UDS service on cisco.
This is the first time I am going to configure directory integration.
It would be helpful if you provide the steps more in detail.
Thanks in advance.
