Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am configuring a ASA 5506 with the built-in WLAN module. When I session into the WLAN module to do configuration, an error continuously posts on screen.
##########INVALID PID -- DEFAULTING TO POWER LEVEL SKU1##########
FW01# session wlan ...
Hi,I have a Catalyst 4003, I have been trying to interface into the WS-X4232-L3 module to access the fast ethernet ports to shutdown some of them. However, I cannot figure out the interface for them? Secondly, the switch is secondhand. Someone left a...
Hi,I'm still pretty new to the networking scene. I'm trying to access the CLI on a Cisco Catalyst 4003 switch.It has a WS-X4012 Supervisor module, a WS-X4232-L3 - Layer 3 Routing Module, and a WS-X4418-GB switching module. Well to make things short a...
Hi Phillipp,
I've looked into the other 5506 I am configuring and I'm getting the same error printing over and over again. I found some more information that says the PID and Software is 702? (I've removed the errors to improve readability).
show...
Hi Phillipp,
Thanks for replying. I am able to run commands like normal and it seems like the WLAN after configuration is operating normally. It just continually prints that error over and over again and then I am not able to exit the session and g...
