Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to figure out how failover works I guess. When the Primary PIX fails over to the secondary PIX does the standby take the IP's and names of the primary unit when it fails over or does it use it's own IP's for the inside/outside interfaces ...
Hi,A co-worker of mine used a command to determine how many bytes per MAC address connected to a switch transferred. I think it might have been an accounting command but I can't seem to get it to work.All I remember is it showed this data based on th...
This is my version:Cisco PIX Security Appliance Software Version 7.0(5)I guess I was looking for the serial number that matches the physical sticker on the device. Show version does show a different serial.Just sucks I can't connect to the standby.
Here is some more info:sh failover state====My State===Primary | Active |====Other State===Secondary | Standby |====Configuration State=== Sync Done====Communication State============Failed Reason==============My Fail Reason:Other Fail Reason:...
That is not a valid command. Here are my options:show failover ? history Show failover switching history interface Show failover command interface information state Show failover internal state information statistics Show failover co...