Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
can we configure dual-active link Detection/Fast Hello and Virtual Link on the same interfaces?hardware model is C9500-40X. the customer wants to save the interfaces and trying to find a way, if there is a way to use only 1 interface(physical or in P...
Some Devices lose ability to ping vlan gateway, but you can manage switch normally. Cannot ping Some devices from the switch or Distribution layer, but switch can ping the gateway. Actions: reset L3 vlan on Distribution = no cha...
we have 4500X as core and trying to run RSPAN for all access Ports on Access Switches(3850 Stacked). access Switches to the core is on L2 and we are trunking all VLANs. when we send Captured packets to Core, it also sends to other access Switches. wa...
for BYOD, can we USE MAC Address instead of Cert ?we have Customer with ISE 2.4, does not wants to use cert onboarding and wants to keep mac address without adding?Flow should be like This. end devices connect to BYOD SSID, then ask for ad user/passw...
we have ISE 2.4 in our environment, Guest Self sign process is working fine, Approved Requests, email sent back to Requestor. but Deny email is not being sent back. can someone help on That?
IOS Code is 16.3.6 ...do not see any things for CPU/FED/HOG in logsbut do see FED in Crashfiles all #show logging | i CPU#show logging | i cpu#show logging | i FED#show logging | i HOG
See Below Configs. we want to stop inter Switch Communication for access Switches for VLAN-999!Core SwitchVLAN 999name spanremote-span!monitor session 1 destination interface Te1/1/10monitor session 1 source remote VLAN 999monitor session 1 filter pa...
we have 2 different type of Cert based on SAN Valve.
1- Prod.xyz.com
2-Test.XYZ.com
and one AD domain group. so we want that if end user has 'Prod.xyz.com' cert and valid ad cerdential, it should have Access to Prod envirement only.
and if end use...
