Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys
Run into an issue with Cisco firepower module, I have a link coming from my ASA management port and going to a switch port within the same VLAN as the firepower module my issue is that on the switch side I have
GigabitEthernet1/0/21 is dow...
Hi Guys
Ran into an issue today with our VOIP service provider, calls were not coming through, a quick call to the service provider suggested to turn of SIP inspection, and yep it works.
My question is if SIP is not being inspected and we have no...
Hi Guys
Ran into a small issue when deploying 9300 switches using radius for authentication, my issue is when trying to authenticate the debug show me that the switch cant contact the radius server, which is strange because I have deployed 5 2960x ...
Hi Guys, recently installed some Cisco 5545-x ASA and along with that now trying to install Cisco Firepower Management Center on a VM, now the installation seems to have gone well, however, I seem to have no connectivity to the default gateway of th...
Hi Alex
check what you suggested and everything seems fine, as far as a most users are aware the VPN was working Friday. As far as I'm aware there have been no changes over the weekend.
Sorry, the radius server is a window box, yes I have defined IP address of the switch 10.50.8.1 and the secret key is the same on both ends. all the other switches I have configured have worked with no issues, but these devices are layer 2 rather tha...
so the radius server is 10.50.1.17 and the switch is 10.50.8.1, I can't see anything except the following
Best Local IP-Address 10.50.1.1 for Radius-Server 10.50.1.17
