About zilla

zilla · 10-10-2018

Is there anything special I need to tell AT&T to get the SIM card activated in my Z3C?I've tried two new AT&T SIMs in a trial unit i have and the Z3C doesn't recognize them. However, if i pop the SIM from my cell phone in the Z3C it works fine.The n...

zilla · 09-27-2018

Anyone else run across this scenario yet?We have an "unrouted" VLAN with an ISP device and the WAN ports of our MX warm spare pair connected to the same MS350 switch. Those are the only ports in the VLAN. The MS350 is not L3 enabled.Because the ISP ...

zilla · 06-24-2019

FYI, the certificate expires in about 26 hours....

zilla · 04-10-2019

I have a similar issue, but a different error.When sending SMS i get an "Invalid" error.I have a case open, but no real progress yet.

zilla · 12-06-2018

Keeping it on a managed switch will let you monitor how much bandwidth the other unit uses. If you go with a cheap unmanaged switch you can't tell who is using all the bandwidth later.

zilla · 11-30-2018

On the Cisco switch side the native VLAN would be 10 in this example.

zilla · 11-13-2018

@Todd Wiler Be sure to get a demo and test it in your lab. We do some redistribution on the MS420s and they don't always act they way you think when you make a change to a route you are injecting into OSPF.

Member Since	‎04-10-2018 11:16 AM
Date Last Visited	‎04-18-2018 04:08 AM
Posts	17
Total Helpful Votes Received	7

User Statistics

User Activity

Z3C cellular activation

IPv6 Auto Configuration for switch management address

Re: [Bug] : Unknow certificate pushed to iOS devices

Re: Recently unable to add new devices to SM

Re: Break out another public IP?

Re: AP meraki on switch Cisco

Re: OSPF static route redistribution on MS switch