Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyoneHas anyone located the software image library as stated at: http://www.cisco.com/en/US/prod/collateral/iosswrel/ps8802/ps6947/ps5413/prod_bulletin0900aecd801e77de_ps5853_Products_Bulletin.htmlThis is where copies of the IOS images are loca...
Hi everyoneI have a Cisco 1812-J router console-connected to a client PC and it is always booting into the rommon prompt. During the boot-up process, it returns this message 'boot: cannot determine first file name on device "flash'." After hours of r...
Hi everyoneI have recently purchased a Cisco 1800 series router and completed its cable connection using a brand new console cable and RS-232 card with two D-Sub 9 pin connectors. The router boots fine and the card is functioning properly but when I ...
Thanks for your replies, that's something worth knowing. I am now wondering if a Cisco partner could lawfully install an IOS image on a second-hand router. Could you tell me if this would be legal?Pommy
Thanks for the reply. It is a second-hand Cisco ISR router which I have purchased and has encountered the problem. Is there a way to obtain an image on a second-hand ISR router?Pommy
Thanks, devmgmt.msc showed me COM3 & COM4, so I tried connecting to both ports with no luck.. But I feel like I've made a few steps towards the solution. Any further suggestion would be appreciated.
Thanks for the prompt reply. I ran Putty and selected the Serial option only to receive an error message saying 'Unable to open connection to Com 1". It keeps baffling me..
