Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to setup up a LAG between my RV345 and an SG300.The user guide tells me to select these ports on the lag management under the GUI and press apply. I do this but then the chosen ports are unselected (as if nothing has been chosen). The ...
To maximize bandwidth I would like to create a nic team on my Esxi 6. Given this is not part virtual distributed switch LACP is not supported on the Esxi side. Route based on IP hash is - and I assume this would handle traffic to my advantageHoweve...
I now have an e-mail from Cisco asking if this answered my question.Well clearly not.So perhaps Cisco you could drop by and answer something you know the answer to instead of handing it off to the "community".Eagerly awaiting a real answer
HiI've seen this link. So let's work with this. "configuration on Cisco side because there is only a simple option to add an interface to Link Aggregation interface. Under LAN->Port settings->Link Aggregation Configuration Table. Just add LAN2 throug...
Yes - but what does static actually mean when connected, to for example aswitch running LACP?The link is rather pointless since it is just a list of more links andnothing on-topic.
The question has not been answered.Say on on RV345 with two ports in a trunk (so a static trunk) - what protocols control traffic?In my case the RV345 connnects to a SG300. So I can trunk two ports on the SG300 side and use a dynamic protocol (LACP)...
