Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys, I have Cat6500 with named ACLs matching L4 traffic configured and applied to L2 port. Software is : (s3223_rp-IPBASEK9-M), Version 12.2(18)SXF5. I cannot use PACL as it requires a bit higher revision number software I believe. The problem...
Hi, I have 2xE1 bundled into multilink interface, ip wccp 62 redirect in on multilink only, ip wccp 61 redirect in on fast0/0. While both serials works - everything is fine and WAAS works smoothly. (4.0.19(b14) ). Problem appeared when we had lot of ...
Hi Ganesh, ACL is pretty simple :Extended IP access list test 5 deny ip any anyint fa1/10interface FastEthernet1/10 switchport switchport access vlan 10 switchport mode access no ip address ip access-group test inresult is that even with this AC...
Igor, 1. generate traffic that you have defined as interesting in your crypto ACL2. from the CLI check : sh crypto isakmp sa3. check if you have phase1 in QM_IDLE state (which is what should be seen)3. from the CLI check :sh crypto ipsec sa peer _ot...
