Limitations of RIPv1 is that it doesn't support router summarization. The below example explains the same, but coudn't under that how route are summarized. Please help on route summarization considering the below example as a limited of RIPv1.
IPv6 Addresses are divided into 3 categories
1. Unicast
2. Multicast
3. Anycast
Unicast addresses are further divided into three sub categories based on the scope:
a. Global Address
b. Unicast Local Address
c. Link Local Address
What is the basic d...
I have studies CCNA, CCNP, and CCIE (R&S) courses but not yet certified, if would like to go for CCIE Exam, is it necessary to be a CCNA & CCNP Certified? or i can attempt CCIE without CCNP certification?
Please assist.
The 0.0.0.0 /0 network is used to identify all networks, and is referredto as the default route. If a default route exists in a routing table, itwill be used only if there is not a more specific route to a particulardestination.
The 0.0.0.0 /8 range is used to identify hosts on the local network.Addresses in this range can only be used as a source address. Themost commonly used address in this range is 0.0.0.0 /32, which a hostwill use when dynamically attempting to learn it...