About pixie79UK

pixie79UK · 02-17-2010

Hi,I have setup the switch below via the console port, with 3 vlans on it, port 1 is a trunk, port 2-4 vlan 2, port 5-11 vlan 3, port 12 vlan 1.I have setup up an ip address on interface vlan1 for the switch so that i can manage it. However if i conn...

pixie79UK · 02-10-2010

Hi,I am trying to setup a 2600 series router so that is has multiple vlans, (office network, wifi, voip). That part i can do easly however, i would like the 2600 to be the dhcp server for each of these networks as well. I can see i need to set each v...

pixie79UK · 02-17-2010

thanks, i had not realised that i entered the ip address in with the wrong ip

pixie79UK · 02-10-2010

ok, i think that does, so you are saying for dhcp pools where the sub interfaces ip matches the default gw of the pool then they will assign an ip from that pool automatically. What about if i were for example to set the default gw for the vlan 3 to ...

pixie79UK · 02-10-2010

If it helps, this is what i have so far which i beleive is correct,!service dhcp!ip dhcp excluded-address 10.208.1.1ip dhcp excluded-address 10.208.2.1ip dhcp excluded-address 10.208.3.1ip dhcp excluded-address 10.208.3.30!ip dhcp pool Network-LAN ne...

pixie79UK · 02-10-2010

accidental reply to wrong post

pixie79UK · 02-10-2010

Hi,Yes i did read the whole of that guide first and understood most of it. I figured i have to create multiple pools one for each vlan and setup the ranges there, which i can do and understand. The but i do not understand is the following two command...

Member Since	‎02-10-2010 08:33 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	8

User Statistics

User Activity

2950 switch - management ip

DHCP Server on a 2600 with multiple Vlans

Re: 2950 switch - management ip

Re: DHCP Server on a 2600 with multiple Vlans

Re: DHCP Server on a 2600 with multiple Vlans

Re: Multiple DHCP scope on router

Re: DHCP Server on a 2600 with multiple Vlans