Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My network is spread over two remote buildings and the distance between them is nearly 800m.I want to connect the Lan of both building by Aironet 340.Each building have 80 nodes or in future it would be expended.Now I need a solution and physical net...
I have cisco 3660 router for my WAN connection and I am using 12.1(3)T cisco IOS for it but problem is that I am facing lot of CRC at my router serial.I have checked my local lead and as well as my whole physical connetivity.The physical connectivity...
I have 3600 series router ,which has 12.0(3)T ios version but this ios version is not supported VPDN,IPSEC,L2TP etc.I want to know ,whcih IOS version is required for VPDN or for those which are describe above.IS my router plateform suitable for VPDN?...
1) EXSTART:After two OSPF neighboring routers establish bi-directional communication and complete DR/BDR election (on multi-access networks), the routers transition to the exstart state. In this state, the neighboring routers establish a master/slave...
you build a access list in which you only permit your lan machines which can telnet on your routers and deny all of networks ip.If you want to allow only certain IP addresses to use Telnet to access the router, you must use the access-class command. ...
