Hi,
Why do we need a layer 3 point to point link between two aggregation switch in addition to the vpc peer link and keep alive link.
What is the pros and cons
Thank you
Hi,
If aggregator and access switches topology is build on clos based , packet would be forwarded using routing ?
so why do we need vpc there ?
Thank you
Hi,
As per cisco best practice ,
" if you use the management interfaces for the peer-keepalive link, you must put a management switch connected to both the active and standby management ports on each vPC peer device ."
http://www.cisco.com/c/en/us/td...
Hi Ganesh,
You were really helpful. Thank you so much .
could you provide a topology diagram wth vpc and non vpc vlan , how traffic flow if peer link alive and fail cases .
It would be really grateful .
Thank you
Hi Ganesh ,
Thank you for the detailed explanation . If i have server connected to a port (orphaned port or non vpc port ) and vlan 60 (Peer link: vlans 10-50 in your picture .) As you said for vlan 60 (here vlan 60 non vpc vlan ?) , we need to cr...
Hi,
you said
" As a general best practice, the VLANs you use for vPC-connected devices should be different from those you use for single-port attached devices (orphaned ports), and you should put those VLANs (the non-vPC VLANs) on atrunk that’s di...
Hi,
I was thinking about a use-case vlan 10 and vlan 11 are not allowed on red link?. What if all vlans are allowed on red link .
link between agg1 and agg2 are vpc-peer link ?.
Why switches are in a domain or why it is called a domain .
Agg1 ...