Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have a client that has 2 ISPs and would like to use ISP1 for employees and ISP2 for guests. At the same time, he would like to have internet failover for both employees and guests.
So, under normal conditions, employee's subnet should use I...
I need to configure qos on CAN switches to improve traffic for 3rd party IP survillance system. I am quite new to video and am not sure what markings I should use. I was thinking of using SPAN to track the conversation between cameras, media/recordin...
After upgrading the IOS on a Cisco Catalyst 3850 and rebooting, the switch gives the following error and can't get out of bootloader mode:
Error loading "flash:packages.conf"
Interrupt within 5 seconds to abort boot process.Boot process failed...
The...
Hi AJ,
Thanks for your quick response.
The part that I'm having a hard time wrapping my head around is NAT. Under normal conditions the employee's subnet would need to be translated to ISP1 (AT&T) public IP address, and the guest's subnet to ISP...
Alex,
I have tried booting from "flash:packages.conf.00-" before, and tried again after I read your reply, but I get the following error:
switch: boot flash:packages.conf.00-Getting rest of imageReading full image into memory....doneflash:cat3k_caa-b...
John,
Thanks for your suggestion. I've tried that before but did not make sure that the USB was FAT16 format. I formated a 1GB thumb drive as FAT16, but get the same error as follows:
### Launching Linux Kernel (flags = 0x5)
All packages are Digitall...
