Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
Current Scenario: We have few access points with 1 WLC (2504) in our Pakistan Office. All APs are in Local Mode and working fine.
Now we have another office in India and we intend to install a couple of 2702i APs there in India Office using F...
Hi Everyone,
I'm working on a wireless solution where we have 2504 WLC, 1700i and 2700i APs.
Software Version 8.1
I have following 2 questions if someone could assist me on these?
Question 1:
I could see 4 QoS profiles (Platinum, Gold, Silver, Bronz...
Hi Ali,
I have a default group and all the current APs are in the default group.
Can I keep the default group as it is, and create a new group for my Remote Office AP?
Or you think I should create 1 group for Head Office and another group for Remote ...
We have Site to Site VPN Connectivity between the sites.
Initially I'd like to keep it simple and would be using PSK at remote office.
Here in main office, we are using LDAP as authentication server.
Could you recommend the best practice to implement...
Hi Scott,
I started a new thread asking the following questions, but no one responded. I though to share here if you could help?
I'm working on a wireless solution where we have 2504 WLC, 1700i and 2700i APs.
Software Version 8.1.102.0
I have foll...
Thanks Scott, let me put all the pieces together.
Internet>>Fire Wall>>L3 SW>>WLC (Trunk Port) and give WLC an IP Address from VLAN10 pool, lets say 192.168.10.1
As the switchport is Trunk, whatever IP I'd give to WLC Management port, the WLC would g...
