Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,Whilst I’m well aware of the limitations of the built in the windows Wireless 802.1x supplicant. Is there a way, using the NAM client to authenticate both a computer and a user simultaneously, when used for authentication to wireless networks...
Hi all,Is anyone aware of any restriction's to using MACSec on the uplinks of a service module whilst the uplink ports are in an etherchannel?Essentially we will have 2x 3560x's connected by 2x fibre's. The plan is to encrypt over these fibre's but t...
HI All,I have an issue with an MPLS design on the 6500's new sup2t's (12.2(50)SY), in that the standby supervisor seems to be dropping VPLS traffic one way. See the diagram below; In this topology everything else works fine, internal routing between ...
Can anyone point me to some guidance on how to restrict SSH access to the ISE nodes from a select number of trusted networks? whilst the WebGUI can be configured to restrict access I can't see a way to easily restrict SSH other putting a firewall inl...
Yeah ours was a fex programming bug.fix was to recreate the port channel and upgrade iOS. I’ll update with the bug id that tac provided when I get onto my laptop
Why would layer 3 routing or hsrp impact the ability for an svi to respond to arp on it’s configured address to a server on the same vlan? This is a layer 2 issue nothing to do with layer 3.Also we do have the peer-gateway and arp sync commands used ...
Hi vinet,In my case it is a windows host doing lacp. The MAC address is shown in both 9ks down the correct interface, however the arp table shows incomplete for the host on one of the 9ks. If I shut the link down to the server from the offending swit...
Hi Clayton,
Did you manage to resolve this issue? I’m seeing the exact same thing on a pair of 9ks.
With the debugs I’ve done we can see arp requests reaching the switch but the switch doesn’t respond to the arp request!
Thanks
