Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using a ASA 5500-X in routed mode currently without NAT. I have routable IP space on the inside that I am adverting/routing to the outside. There has be a request to setup Anyconnect VPN for remote access. Normally you just set the "outside" int...
A little background.
We have small remote sites with Cisco 2901 routers all with 8 port D8ESGP(ESW) in them and they all use T1 interfaces for their WAN up-links.
I want to use the 2 routed ports on the device as access ports at some of the sites tha...
With an ASA is there a way for it to allow scp(port 22) traffic from a host to another host but deny ssh(port 22)? Obviously this an encrypted protocol but I do not know if there is some difference between the two that can be matched.
I currently have the timeout set to 14400. I have been draging this along in my config for a long time."arp timeout 14400"My question is what is the recommendation for the timeout? 4 hours seems like a long time.
In the examples I have found on setting up L2L IPSec connections when they create the traffic matching ACL for the crypto map they show a single subnet to single subnet ACL and just flip the source and destination for the other side.For example:Route...
Thanks for all these ideas and thank you Julio for the link, unfortunately....
It looks like the EHWIC switch card doesn't support bridging.
AKN-RTR(config)#interface GigabitEthernet0/1/0AKN-RTR(config-if)#bridge-group 1GigabitEthernet0/1/0 does n...
Correct I have the SVI setup and all the ports on the switch ehwic assigned to it and I want to use the two ports on the router on the same vlan.
We only have a few sites that need an additional port over the 8. I just hate to have to buy external s...
Thank You. That did reslove the issue.My next question is I thought proxy arp was off by default? This is running an 8.2.x build(I know I need to upgrade).I can not seem find anywhere in my config where I am enabling it? Any ideas?
