Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello! I'm doing some tasks on PT. I found one where I have a 2800 Router and I'm trying to assign a VLAN to Fa0/1 but cannot seem to find the command to do so.Router#show running-config:SpoilerBuilding configuration... Current configuration : 779 by...
If you ever run into this bug, try killing Webex.app, then the AppleCameraAssistant with kill -s HUP (pid) and then run Webex as sudo, it worked for me.
Hello! I'm running Webex 49.0 on Catalina (I know, old, but it's all I got, my specs are still good though, i3 with 8G ram). A complete RAM hog, when Webex running, 11 1GB paging files, when I kill the app, goes down to 3 paging files.Webex for macOS...
Hello, I'm starting with PT. Thing is, I wanna start from the very basic (learning to read the PDUs properly, analysing them and simply learning more about the very core), however, one of the very problems I find, is that when running a ping from one...
Yessir! That was it. I hadn't whitelisted ICMP in the outside interface. Thank you!! PS: Do you know how to run debug level logging on the CLI? I only managed to get it working on ADSM. Thanks again!
For example, if I try to ping out from a VM behind 10.10.10.1 (ASA) : # ip route show
default via 10.10.10.1 dev eth0 proto dhcp
10.10.10.0/28 dev eth0 proto kernel scope link src 10.10.10.3
# ping 8.8.8.8
PING 8.8.8.8 (8.8.8.8) 56(84) bytes of da...
