Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a CISCO ASA to get Internet, some VPNs, etc. and I have a MPLS to connect other Location, I want to Block certain traffic on this MPLS through the FW, but it seems that the ACLs that I created under ACL Manager are not working, the traff...
Hello, I need to add QOS to the VPN between 2 Locations that are working under a Site-to-Site VPN, both of them have Cisco ASA. VPN is established. I need to add the highest priority to the following connections:SQL Data ConnectionsRDP Data Connectio...
Hello,I have 2 LANs connected across a VPN Site to Site with 2 Cisco ASA 5500, it is working OK, but on one of the ASAs the AnyConnect users need to connect to the other LAN accross the VPN, is that possible, here are a basic diagram that I made for ...
Hello,
We have a Firepower Cisco for WEB Filtering, we have some Policies created already, but I want to Exclude an specific Host or IP, I tried to add the Rule on Access Control Policy as following (1st Rule) but it does not work, still blocking m...
Sometimes, the FW did not take all the Subnets on the Phase 2, so try this:Move the Subnets that are not working to the Top of the ACL od the CryptoMapAnd validate.
Solution to this:Steps to perform at LAN 1 ASA1. Add Anyconnect VPN Subnet to Crypto ACL to allow for site to site VPN .2. Allow access from Anyconnect VPN subnet to LAN2 Subnet in Anyconnect VPN.3. Add No NAT for Anyconnect VPN Subnet.Steps to perfo...
How can I add the NO-NAT/NAT Rule, at this moment, this the the rule that has been created on automatically after I created the VPN Site to Site. Where am I going to create that rule on?
