Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Running 3750 in stack Version 15.0(2)SE2I am geting error when trying to add vrf vlan intswitch(config)#interface Vlan101switch(config-if)#ip vrf forwarding dummy% CEF table 0x6 does not exist (Vlan101).switch(config-if)#^ZPlease help
Hi I am trying to configure cisco Pix firewall but not sure if the firewall is faulty or I am missing something I started with interface configs and i am not able to give IP to the interfacepixfirewall(config)# int ethernet 1pixfirewall(config-if)# i...
HiI am having a ASR 1002 V 12.2(33)XND2twhich is running on TacasI want when i login it shoudl directly go into the # prompt. I am not interested in typing enable on > prompt. The configs are aa new-modelaaa authentication login default ...
I am trying to enable wccp on 6509. Its works fine on port 80 but not with https (443).Also i have noticed when i use the followingip wccp web-cache redirect insimilarly adding to interface http works. but when i use the service no 0 instad of web-ca...
I have tried to delete vrf and vlans. Tried it ont another vlan interface but same errorTried creating vrf using vrf defination.getting same erro when tring to add vrf to loopback interface too,switch(config)#interface Loopback1switch(config-if)#ip ...
Yes Cef is by default on the switch i believeswitch#sh ip cefPrefix Next Hop Interface0.0.0.0/0 10.34.68.1 FastEthernet00.0.0.0/8 drop0.0.0.0/32 receive10.34.68.0/24 attached...
I just want to assign the IP addresses to the interfaces. Pref. without sub interfacestried giving the names as well but still not showing the ip addresspixfirewall(config-if)# int Ethernet1.100pixfirewall(config-subif)# namepixfirewall(config-subif)...
