Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Following configuration done on the switch 3750 for a customer for their video network. i have to clarrify few point with this configuration.1. Qos configuration done for muticast(decimal value 34) & unicast(decimal value 36) traffic ensure high p...
All,I want to restrict bandwidth on the perimeter router for a particular IP access to 5Mb. total interent bandwidth available with us is 12 Mb. following is the configuration done inoder to achive this. but it seems its not limiting to 5mb as i can ...
Hi All,Following is the configuration done for SSL vpn on our ASA 5510. . though we did the configuration refering the site we are unable to get the login prompt. could you please check and suggest to make SSL vpn workingConfiguration==========...
Dear All,We are unable to access webmail from inside ips using https://mail.companyname . but we can access same thing from outside internet.We use IP from our pool public IP for PAT as well as this webmail natting.Is there any way we can access web...
Dear thanks for your reply...Sorry for the late written reply.1. Mean while the following line does it mean the queue 1 get only 60% ? is it?mls qos queue-set output 2 buffers 60 20 10 102. Could you pl brief the following config regarding queue-set...
pl see the out put . if i change bandwidth command in interface will there be any impactRTR2800-1#sh int fastEthernet 0/1 rate-limitFastEthernet0/1 Du_ILL_12Mbps Output matches: access-group 100 params: 6000000 bps, 30000 limit, 30000 exten...
Please find the out put from the router. sh service-policy command is not working ...RTR2800-1#sh service-policy ^% Invalid input detected at '^' marker.RTR2800-1# sh intFastEthernet0/0 is up, line protocol is up Hardware is Gt9...
Hi,Thanks for the reply.Meanwhile i want to restrict only traffic destined to one network (168.161.247.0 0.0.0.255). rest all access should be allowed get full bandwidth. is that can be done?is there anyway to do it?
