Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi al,I rebuilt a asa5506 on 9.14 but I can't seem to access the internal network over secure connect.Split tunnel and nat is configure, I see the hit counts and it is getting dropped by acl. Any thoughts?hs1rt1# sho vpn-sessiondb anyconnectSession T...
I am trying to add a new C2950-4 switch to ASA but some for reason the nearby 2950-2 will get shutdown due to spanning tree messages as soon as the interface is active.ASA Port 1 is connected to a daisy-chain style C2950s and ASA port 2 is connected ...
Every weekend at specific time we observed the following message in the log in couple N4Ks. Have anyone see this?I looked up in Cisco documentation but cannot find anything on it except I know TOS stands of Type Of Service?2014 Aug 23 03:00:01 N4K %D...
I have a flat network with one VLAN in ASA 5500 and I am trying to divide it into multiple segerated VLANs. Later I found out it is not possibile to ping the closest interface as it is by design.For instance, vlan2 is not able to ping 192.168.1.1 in ...
I have 1130 on each floor and planning to add 1141 AP for coverage / redendency. Does it matter if I mix and match on the models? I am using Radius.Should I "deploy" the identical model on the same floor?
@MHM Cisco World After adding the NAT rule and noticing packet-tracer to phase 19 I found out the ip I am testing is the culprit. (I was able to ping from ASA so I didn't pay attention) I tested using other ip address in the same subnet and I was abl...
Added the following get it further but connectivity still not passing through. Any thoughts?@hstf_techy wrote:Hi al,I rebuilt a asa5506 on 9.14 but I can't seem to access the internal network over secure connect.Split tunnel and nat is configure, I s...
Sure. Here it is - # packet-tracer input outside tcp 172.16.16.199 59548 192.168.100.250 80Phase: 1Type: ROUTE-LOOKUPSubtype: No ECMP load balancingResult: ALLOWConfig:Additional Information:Destination is locally connected. No ECMP load balancing.Fo...
