Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello - I have set up a Remote access VPN on an ASA. The tunnell seem to come up ok but I cannot access any local resources. I have searched the forums and google and for some reason cannot get it to work. Could someone have a look for me and point...
Hello - I am seeing a whole bunch of the below messages in my logs. Can anyone tell my why this is happening and how I can resolve the issue. I have tried tunning the setting below with no luck. Dec 16 08:55:47.195 WA: %IPS-4-SIGNATURE: Sig:1304 Sub...
Hello - I have a Cisco 881 version with IOS 15.1. it appears to only have 1 WAN port (fe4) and 4 layer 2 port 0-3. Is there a way that I can configure one of the layer 2 ports as a WAN ports for load balancing and redundancy as we have 2 ISP comin...
Hello - I have a Cisco 881 W router connected on port fa4 (WAN) to my cable ISP. Behind that (LAN side) I have created a VLAN 50 on port fa1 that runs to a Watchguard (XTM 2 series) to the External port. From there things are running smoothly as I ha...
It doesnt have any wireless antenna's. The one I thought I ordered had antenna's is this a extra added accessory i need to order. It appears on the back that there isnt even a place to connect them.gm
Thanks for reply. I changed the NONAT statement statement as suggested above and it still isn't working. I did get it working by adding a ACL to the outside and inside interfaces permitting the specific VPN traffic. I was under the understanding th...
Thanks for reply - I have the Advanced IP Services image. I have tried the statements below but its no working for me....the 10.0.50.1 is the external port on the Watchguard......ip nat inside source static 10.0.50.1 74.94.67.???ip nat source static...