Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I have a serious problem (see attached topology)From R1 and R2 i can ping subunterface 10.222.180.1 on R3 but with packet losses ,but i can ping the rest subinterfaces 100%.Also from R3 i receive packet losses when i ping 10.222.180.1( which ...
Hi,Currently we have 2 ISPs and the company is going to buy a new 1 by next week.And am supposed to configure redundancy and multihoming ,Please can any one give me an idea how i can achive this?
Hi Guys,I got the solution,there was a command rate-limit configured on the subinterface. It was the one causing problems, after i removed it ,everything is fine now.Thanks for your assistance.
Hi,I have just added another router R4 10.222.180.7i can ping 10.222.180.1 100% ,as well as 10.222.180.3 and 10.222.180.4From R1(10.222.180.4) i can reach 10.222.180.7 100% (though it stucks stucks)..............
Here we go.from where you pinged ther is VLAN1 only? YES#######################################################################################R1#ping 10.222.180.1 repeat 100Type escape sequence to abort.Sending 100, 100-byte ICMP Echos to 41.222.180...
