Hi All, I am facing lot of challenges related to CEF issue in IOS-XR. Router shows Glean adjacency for connected IP subnets.Sometime issue gets resolved by rebooting routers, but many a times it doesn't get resolved even after doing so. To troubles...
Hi,I am seeking a quick expert input that can I use IMA-ATM-E1 card for terminating ATM E1 link in Cisco 2851 router.If yes, then is there any specific minimum IOS version requirement.Thanks.Regards,Arun Seetha
We are in planning phase of a network design, wherein it is required to setup a network comprising of Cisco 2811 as WAN edge routers.Need to understand that how many GRE and IPSec tunnels supported by this platform.Thanks in advance.
Hi All,I have a query regarding NM-8CE1T1-PRI card installed on Cisco 3845 router.Data sheet states that maximum 128 channels can be used by this card on this router. Ideally it should support 8*32=256 channels.Can't I use 256 channels so that I can ...
Hi Xander , Thanks for your time and efforts to explain it.In your example, you referred outputs for three IP Addresses 54.1.1.1/32, 54.1.1.2/32 and 54.1.1.3/32.In the output of 54.1.1.3/32, Adjacency shows as Glean, which I could not understand. You...
Hi,This is must to form OSPF neighborship that both routers should be part of same IP subnet.I would suggest you to check IRB (Integrated Routing abd Bridging configuration) of Cisco. This is like like extending LAN over WAN.Try makeing the below men...
Does this mean that maximum 16 channel-groups can be configured including all 8 ports; where any Channel-group can have any number of actual DS0-64 Kbps channales.So in this case, say we need 256 Kbps then we will bind 4 DS0 64-kbps channels in one C...