Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am trying to control the networks that are being advertised from our ASR to our Palo. I have been able to get the advertisements to work with the prefix-list but I am having an issue trying to advertise a smaller block then what we are seein...
I have a 5020 setup with inter-vlan and am able to ping devices across the vlans. I am also able to ping the outside 8.8.8.8 from the 5020. If I point an end device to use the 5020 for the gateway it can't ping past the 5020. There is a firewall conn...
I need to configure an MDS 9222i to do EhterChannel for redundant links to a Cisco 6500. I have tried to configure channel-group on the GE interface and I get an error (see below)b0maumigrjax(config-if)# channel-group 1command failed: Member list of ...
Harold,
Thanks for the update. That is what I figured the answer was going to be. I was hoping there was a way to do that with BGP routing between the ASR and Palo. I think I will just end up doing static routes in the Palo to make the routing decisi...
Hello Jack,I had the same problem. The way I got around it was to unzip the .ovf using 7-zip. Once un-zipped you will find another .ovf file in the folder. Do the import with that file and it should work.
I am running ESXi 5.1.0 with the latest patches. I tried it on 3 different ESXi servers and they all had the same issues. I have installed other UCS Emulators and currently have v2 running as a VM and no issues. Not sure what is going on with it. I w...
So I tried to do the import in vCenter again and manually removed the NIC's and added them back and it still does not properly boot and just hangs. Once that happens ESXi server becomes unstable and the VM will not shutdown.The only way I was able to...