Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 4710 ACE load balancer with three virtual contexts, i have configured the three contexts with the syslog configuration to send the logs to a syslog server as below:logging enablelogging trap 5logging buffered 7logging host 10.x.x.x udp/514I ca...
I have 4710 ACE load balancer with three virtual contexts, i have configured the three contexts with the syslog configuration to send the logs to a syslog server as below:logging enablelogging trap 5logging buffered 7logging host 10.x.x.x udp/514the ...
there is packets drops in the access switch interfaces which connect to the IP phones which cousing call disconnet or unclear voice. below some show command from the switch and for example i choosed interface 1/0/8: GigabitEthernet1/0/8 is up, line p...
Router 2 receiving source attack from two sources in OSPF area 1. Need to find these Two sources and block their traffic before they enter into OSPF area by using proper access-list. The traffic from other networks should not b...
there is an attack coming to my router from interface eth 0/0 i want to protect my router by block the attacker from entering the ospf area using an access-list.
Actually this configuration done by someone alse and I am trying to stop the packet drops, what is I try to remove the mls qos srr-queue output dscp-map queue 3 threshold 1 0 command from the switch and do the test again??
hi joseph thanks for you answer,Actually PQ not enabled and the IOS version is " flash:c3750-ipbasek9-mz.122-50.SE3.bin"which soulution you think will be the best to solve this issure with modifing the existing configuration ??
