Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a setup where managment interface is in different vlan, ap-manager is in different vlan, APs are in different vlan and the clients are on their own vlans respectively. Everything works except for when I try to associate a client to an ap ...
Hi all, I am running a 2 MSE, 4 Controller setup, all managed by the WCS server. I am trying to configure the wIPS profile. I am able to create the profiles and when I go to apply it to the MSEs I get an error message. Each MSE has two controlle...
I have configured a controller with a IP address, everything is working, I can get to the controller from the sup 720. and I can get to anywhere on the network from the router. but when I try to http into the controller from the network it doesn't r...
We are trying to connect both NICs of the MSE to our server switch. Is there any configuration in the MSE that needs to be done in order to accomplish that task?What would be the best way to do it?
What command should I use to clear all my configs off of a Sup720 running 12.2(33)SXI2aI have tried clear config all but it doesn't recognize that command??
OK so I found out that there is a bug for 12.2(33)SXI2a;As discussed the bug you are hitting is CSCsw51658.Symptom:- WISM with factory defaults is not acquiring IP address on autoconfig.Conditions:- This only happens with SXI because its on SXI that ...
executed the command and still getting the same error message...c1swlan(config)#int range g7/1-4% GigabitEthernet7/1 interface cannot be modified please change the range% Command rejected: Interface is not configurablec1swlan(config)#
