try to set you 1st vnic to fabric A, and 2nd vnic to fabric B and enable auto fail over. After that, try to reset the connectivity on both fabric for the specified blade. You should have the uplink configured for Ethernet which I assumed. Regards,Cra...
I dun think they have any calculator for this, as you should combine the network, storage, compute into 1 to justified the calculation due to the UCS architecture are totally different from the traditional server we used previously.
if you plan to perform stateless computing, highly recommend to stick with SAN boot. Theoretically by the way you perform it should be work, but I had never done that b4 in UCS. I had performed the similar activities on others rack mount servers, wha...
You may only need to reset the 6120 as the chassis itself do not contain too much information, of course, is recommend to format all the local HDD if you are not performing SAN boot environment in your test.You can do this from the CLI by SSH to the ...