03-08-2010 04:06 AM - edited 03-01-2019 09:37 AM
Does anyone know how to reset a UCS system to factory defaults? We have a UCS lab at the office and we need to be able to reset everything back to factory defaults so that multiple people can learn how to build a UCS system from the ground up.
Solved! Go to Solution.
03-08-2010 12:43 PM
Glad that worked.
Here's a direct link to the command in our documentation:
You can find the full guides here:
http://www.cisco.com/en/US/products/ps10281/products_installation_and_configuration_guides_list.html
--Justin
03-08-2010 07:48 AM
You may only need to reset the 6120 as the chassis itself do not contain too much information, of course, is recommend to format all the local HDD if you are not performing SAN boot environment in your test.
You can do this from the CLI by SSH to the 6120 switches.
03-08-2010 09:44 AM
SSH to your 6100
#connect local-mgmt
#erase configuration
Simple as that
--Justin
03-08-2010 12:31 PM
That did it, thank you very much. Is that in the UCS documentation anywhere?
03-08-2010 12:43 PM
Glad that worked.
Here's a direct link to the command in our documentation:
You can find the full guides here:
http://www.cisco.com/en/US/products/ps10281/products_installation_and_configuration_guides_list.html
--Justin
05-07-2018 11:33 AM
hi, good afternoon,
i have three doub,
1.- could i use any serial wire to attach to the enclosure and reset all the configuration using putty or there is a specific serial wire to use with UCS enclosure?
2.-i have to use console port or MGMT port to do it?
3.- wich is the configuration on putty to get serial conecction, i mean wich values have i configure on putty to get connection with the enclosure by serial port?
hope you could help me.
best regards.
05-07-2018 11:42 AM
1. You need to use a serial console cable. This is the same cable that is used on any device's serial console.
2. console port
3. 9600 baud / COM X - X being the port you are connecting.
05-07-2018 11:54 AM
thank you by your answer,
when you say console cable do you meant to this one cisco
i use this,but i can't get conecction, putty only open a black windows without load anything
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide