Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi - I have a issue on a router where subnets learnt by EIGRP are getting put into the routing table over eBGP routes. I have not modified the default distance of BGP. I do not understand why this is the case. eBGP with admin distance 20 should be mo...
HiWe are seeing small but incrementing amounts on ignored input errors on our 2821 routers. The are incrementing on both the WAN and LAN interfaces (both are ethernet interfaces). I would like to understand possible causes. The error rate is extreme...
Hi all. I want to configure a route-map to route traffic to null0. Is this possible somehow? Null0 doesn't seem to be an option with the "set ip next-hop" cmd. Or is there another way of doing this. Background - I want to blackhole any traffic with a...
Hi - I have a wan which is a MPLS cloud. Access to the cloud from the router is for instance a 100M ethernet connection however we pay the provider for say 10M access. I want to ideally shape my outbound traffic to 10M and I don't want any packets to...
I have got this working - but I'm not 100% in the correct method. What I found was that I didn't have the "access-group input ACL1"applied under my vlan 50 (mgmt interface) on the ACE. When I apply this I can route to my bridged subnet successfully f...
yes this makes sense. I tried to create a Interface VLAN on the MSFC for the gateway for the real servers - but I get the error--------------------------------------------switch(config)#int vlan 52switch(config-if)#ip address 192.168.2.2 255.255.255....
