Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'd like to know if anyone has successfully configured LACP on 1000V? I'm having problem with LACP where etherchannels are not establishing. If I don't use LACP, and turn on etherchannel unconditionally, then it works fine. My 1000v is connected to 3...
I have an ESX host with 4 NICs and I added all four NICs to the 1000V DVS. All of the four NICs are part of a single port-profile (system-uplink). After I did that, everything works fine except the datastores are now not accessible. The datastores is...
I have WCS ver 4.1.83.0. I'm trying to apply an AP template to my APs. But when I try to search the APs by using Floor Area, I'm getting error saying "Failed to contact server. Please make sure you are logged in and have network connectivity.". (See ...
I'm having hundreds of alarms showing up on my WCS. I'd like to know if anyone knows what these are. And any way to fix it.Message MFP Anomaly Detected - 136 'Invalid MIC' violation(s) have originated from the AP with BSS '11:11:11:11:11:11'. This w...
Thanks for BugID. It does seem that I'm hit with the bug. But also, I notice that I also need to add two more spanning-tree commands for my environment (with AIPC). Found this on 1000V document.http://www.cisco.com/en/US/docs/switches/datacenter/nexu...
It depends where your VSM is. If your VSM is sitting on a different ESX host (which is recommended not to be on the same ESX host to be managed by 1000V DVS), then you will need Control/Packet (and mgmt) vlans on your N5K and any other switches in be...
Hope you have already figured this out. But if not, you may want to verify your system-uplink port-profile configuration. I've used HP blade and 3120 blade switch and ESX hosts each has 4 NICs interconnect to the 3120. I moved all 4 NICs (as one ethe...
You don't need to use separate physical NIC for Control/Packet and Mgmt. You can use a single vlan trunk port (etherchannel or non-etherchannel) to carry all three vlans (control, packet, management). Just make sure you specify them as system vlans i...
