Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, i have the following problem ...we have printers on local network 192.168.100.XXX ....<-- DHCP is disablesour Cisco Wirless LAN Controller is on different network 192.168.105.XXX .... <-- DHCP enabledthe wirless device is connected to the l...
heey everyone ....we are using a Cisco 3560 Switches here at the office.how can i configure smtp mail server on my switch?i want my switch to send me an alert if a certain port reaches a certain level of utilization?can this be done ...awaiting your ...
Dear All,i am facing an issue continously when configuring a VPN Connection with any client. what is happening is the tunnel is a one sided initiation means that i have to send some packets from my side so the other side will be able to connect to my...
i hope this is clear ...so can what configuration i have to enable any wirless user to print through local printers.Printer doesn't have wireless !!i am not trying to give you a hard time but i really need your help in this.
heey there ,,,that's the problem am facing ... i have an HP Printer but no wireless option is there ...but i was thinking that since the two networks have the same GW ... there might be a way of allowing wireless users to print through local printer...
hey ganeshh.iyer ....this been of great help .... thanks alot +8 however, is there any direct commands i can use on the cisco switch to have this alert system. i mean without enabling/configuring SNMP.
heey guys ....i have checked all your suggestions nothing seems to work ...i think it might be a problem of integrating different platforms cause the other side is using another VPN device (Check Point)thanks all for your help ...
hey there ... first of all thanks for the response it really expands my troubleshooting process ... regarding the natting ... both sides are using public IPs so i dont think natting is used at both sides. in ASA do i have to configure the ACL in both...
