Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!I been thinking quite a long time over this and i hope anyone here could help out.Is it possible to "route" traffic through outside interface and depending on what ip adress you are coming from you are directed to a specific ip on the inside? I kn...
Hi, This is the first time I setup a new Sisco network. I got this equipment:Sisco 520 WLC2x AP521GASA 5505 Series FWNow I have managed to handle all settings regarding DNS, WAN/LAN / DHCP and even WLAN with WAP encryption for internal users. Now I w...
Hi!I need some help how to allow smtp traffic to a exchangeserver on lanside.I tried:access-list out-to-in permit tcp any host 192.168.0.3 eq smtpaccess-group out-to-in in interface outsidestatic (inside,outside) 192.168.0.3 xxx.xxx.xxx.244 netmask 2...
Hi!I need some help with how to config a 3500 catalyst switch to logg everything (logging trap 6) to a syslog server. This switch has some commands and vlans configured since earlier (not by me).Please explain the following lines for me:logging facil...
Hi!I would like to send all events to begin with. But the Eventsmanager doesnt get any syslog activity. Is there other steps i need to do on the switch other then ->Logging myhostname?If i want to monitor almost every event is default settiing good f...
Hi again!Thanks i will try this. I looks a bit backward to me (Cisco logic?!) but is the 12.12.12.20 (21) adress an outside adress equal to orginating adress that i tried to explain? Lan inside should be 192.168.0.21 (22). Correct?Regards,Mattias
Hi!From outside i want to allow traffic to inside depending of what ip you are originating from.Lets say FW Outside IP is 10.10.10.10Inside is 192.168.0.0.Example:Ip adresses that i want to get "full access" to internal ip isOuside ip 12.12.12.20 for...
Thanks for your reply! I added some more static statement and access-list and now i'm getting performance issues from inside firewall (not sure from outside). When trying to send or recieve files it's really slow. We have 10/mbit up/down via fiber. W...
Thanks for your reply! I added some more static statement and access-list and now i'm getting performance issues from inside firewall (not sure from outside). When trying to send or recieve files it's really slow. We have 10/mbit up/down via fiber. W...
