Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to be access network resources on the outside from the Inside interface IP address. I have been unable to pass any traffic originating from the INSIDE interface adress to anywehere on the outside of the network. Other INSIDE traffic is working...
Can the 2960 have more than one trunk port?I'm trying to configure 5 ports as trunk ports on one of my 2960 switches but only one seems to work. The other 4 ports get placed into VLAN 1, and cease to function no matter what the configuration says. VL...
I have a wierd network design and am having no luck figuring this out.Here is the setup:1. One ASA 5520 connected to Internet on outside interface.2. Inside physical interface has no IP address but has 11 internal VLAN sub interfaces with PUBLIC ip a...
Hello, I have an ASA 5520 with 11 vlans configured on "internal" sub-interfaces and one interface configured for outside.The ASA device is routing traffic correctly between vlans and outside interface but the sub-interfaces will not resopnd to ping o...
How many ports on a 2950 can be configured as dot1q trunks? I need to place an intermediary switch in my network to pass trunk data beween 10 other Cisco switches and therefore need to configure 10 ports as trunk ports. Is this possible or would a d...
Exactly! I was hoping the ASA could do this but it's not looking good. Although I don't understand why the INSIDE interface can't connect to outside resources when everything else on inside of the inside interface can.
Close I have: aaa-server SERVERNAME (INSIDE) host x.x.x.x host x.x.x.x is unfortunately on the outside of my network.The traffic to the LDAP server( which I have no control over) is required to be from the INSIDE address range. The OUTSIDE add...
Yes, trying to get ASA to talk directly to LDAP server Yes, ASA is VPN connection point and I'm using Cisco VPN client. VPN is working fine now but I have to utilize LDAP for user accounts instead of the local ASA database.
Gig 0/48 is connected to the unmanaged L2 switch. The other trunk ports from different bldg are connected to the unmanaged L2 switch as well.I attached a simplified diagram of our network. I suspect the unmanaged switches will have to go.
Hi Ankur, thanks for your reply. I attached running config and show int outputs.Could the problems be due to use of unmanaged layer2 switch used to connect trunk ports from each building?Basically , I have 2960's for wkstn access in each bldg, ea...
