Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ladies/Gents,Forgive me since this seems to be a grossly incompetent question. I have been scouring cisco support and cannot find out what the deaultis for IP CEF on cat switch hardware (i.e. 35xx, 29xx, 37xx, 45xx and 65xx).Is CEF only applicable o...
I am trying to look up (via CL Lookup Tool - not sure if thats the appropriate venue).As to when you configure.1. A Switch out of the box what the default admin status is of all ports (shutdown or not).2. A Router out of the box what default admin ...
CLT inspect esmtp - default = enabled for 7.2 and 8.0Master Command Reference Document = disabled for 7.2 and 8.0Anyone in production that can verify which one is indeed correct.Jim Abercromby CCNP
It appears (to me at least) that the documentation (Command References) and command lookup tool provide elusive/and almost contradict each other on what the default behavior is) for:no ip gratuitous-arpsip gratuitous-arpsOn top of that it appears tha...
I have been reading and reading and trying to figure out the defaults for 'ip cef' and 'ip cef distributed' on Catalyst Switches.i.e. 3750, 3560s, 2950s, 2940s, 4500s and 6500s.Wouldn't/Isn't the default that Cisco Expressing Forwarding is enabled.Th...
Mr. Ortiz, I just read all the documentation for the 'shutdown' command. From what I see here interfaces are 'enabled' bydefault.We on a test lab I have running 3640s, running the following images and modules, I see the OPPOSITE behavior.i.e. DIS...
Sushi,If you look at the html content i.e. Command Refs for these yes it shows inspect esmtp as being enabled by defaultand the Command Lookup Tool states as such.If you actually download the .pdf command reference booksfor 8.0, 8.0(4) and 7.2(2) you...
Sushi,Cisco Security Appliance Command Reference For the Cisco ASA 5500 Series and Cisco PIX 500 series.Software version 8.0(4) - revision number differentJust looked at it again disabled by default.Cisco Security Appliance Command Reference For the ...
Let me make sure I have this straightFor IOS/Router platforms = 'ip gratuitous arps'disabled by default since 12.2For Catalyst/Switch (MLS) etc. = 'ip arp inspection' This is disabled by default too.So if I am looking to see if a catalyst switch isfi...
