Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have excessive errors on port fa0/24 which connects to my Cisco Router. Anyone have any ideas as to how I can resolve the undersize errors on this port?Thanks.Core# show int counters errorsPort Align-Err FCS-Err Xmit-Err Rcv-Err Und...
Interfaces that will be enabled at the next timeout:Interface Errdisable reason Time left(sec)--------- ----------------- -------------- Lo0/16 link-flap 256 Lo0/21 link-flap 258LRE-Switch-20#...
WS-C2924-LRE-XLflash:c2900xl-c3h2l9s-mz.120-5.WC8.binWhat is the difference between the status from "show int status", in comparison with "show controller lre status link"?I currently see the following:*Show int status Lo0/22 connected 1 Half A-10 1...
I have a Cisco 2600 with multiple inside VLANs. How would I limit the usage on a specific VLAN?Using 4250 out of 29688 bytes!version 12.1no service single-slot-reload-enableservice nagleservice tcp-keepalives-inservice tcp-keepalives-outservice time...
WAP2 [Cisco 1200 Series AP 12.03T] Uptime: 00:03:25When loading this unit I am trying to flash it with a new firmware. I hold the MODE button in when I attach power but it does not try to grab firmware from 10.0.0.x TFTP server.Any ideas?...
