Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Some of the information is sensitive, so I will briefly describe the problem I am having. Below is an example of network topology:Router <-> Switch <-> Encryptor-><-Encryptor <-> SwitchCurrently, the network is running OSPF through IPSec tunneling. T...
Hello,
I am quite puzzled with the issue I am having. In my test, I had route-leaking setup. Saved the configurations and turned off the router. Next time I boot up the routers, my route-leaking isn't working.
Problem:1) Computer VRF cannot ping any...
Hello,
Problem:I have a 6500 series switch that I am trying to set up multiple tunnels on. I have followed the instructions of the diagram below, but my tunnel on the 6500 series switch will not communicate with the other tunnels. The only change I'...
Problem:
Reoccurring high utilization for NTP
Version:
Cisco IOS Software, s72033_rp Software (s72033_rp-ADVIPSERVICESK9-M), Version 15.1(2)SY7, RELEASE SOFTWARE (fc4)
CPU:
CPU utilization for five seconds: 77%/1%; one minute: 76%; five minutes: 74...
Hello,
Could someone explain to me what are route-maps and how they work? I am trying to understand it a little in my lab, but I don't think I am grasping it too well.
Here's my scenario:
I have two groups: LAN and Wi-Fi. The IPs associated with each...
Paul, No, this is not quite a DMVPN topology. I can explain as much as possible.The router is controlled by an outside source. The swith connected to the router is the starting point of our connection of what I control. We are using OSPF via GRE tunn...
Georg,The issue is not in the fact on the end switches, which this is doable. The issue lies on the core switch connecting to the router. We are wanting to move away from static routing every route because it will turn out to be over 120 static route...
Francesco,
Sorry, I wasn't able to do anything today. I will get you the configs. Let me know what time works best for you with the timezone. I'll make sure I set the time aside to be able to troubleshoot.
